Werbung
Verfügbare Sprachen
Verfügbare Sprachen
em2go
EM022AC1RA | EM022AS0RA
Cable Type (CT)
The 22 kW EV charger has an RFID card reader that allows the charger to be turned
on and off.
The built-in current control allows you to adjust the output current by limiting the
current draw. The output current can be set to 10, 16, 20, 24 and 32A.
Procedure
1. The charger is equipped with a CEE plug 3-phase and 32A, connect the CEE plug to an
appropriate CEE 3-phase 32A mains socket.
2. Turn on the charger with the RFID card. Press the switch on the side to set the current
consumption limit. The set value is saved.
Please note you can only switch the charging current before connecting the plug to the
vehicle.
3. Before connecting the plug to the vehicle, the charger must be switched off after the current
has been set. Turn off the charger by holding the RFID card in front of it.
4. Now the EV charger can be connected to the vehicle. By holding the RFID card in front
of it, the charger will turn on and charging will begin.
5. When the charging is finished, please just hold the RFID card in front of it and the charger
will turn off.
The output current setting will remain until it is changed again.
em2go
D-Parts Mobilphon & Zubehör GmbH • Birkenweiher Str. 16 • 63505 Langenselbold, Germany
Socket Type (ST)
www.em2go.de
ist eine eingetragene Marke der D-Parts Mobilphon & Zubehör GmbH
RFID
/ www.d-parts.de
Werbung
