Einführung Dieser Leitfaden beschreibt die Möglichkeiten, die EM2GO-EV-Ladestationen der Duo Power-Serie auf die Werkseinstellungen zurückzusetzen. Bei Bedarf kann die Ladestation auf die Werkseinstellungen (Standardwerte) zurückgesetzt werden. Das Zurücksetzen auf die Werkseinstellungen kann auf drei Arten erfolgen: • Mit einem OCPP-Backend •...
Klicken Sie auf die Schaltfläche "Factory Reset". Die EV-Ladestation wird die Standardwerte laden. Um die EV-Ladestation neu zu starten, klicken Sie auf die Schaltfläche "Reboot". Werkseinstellung mittels Taste Falls kein Zugriff auf das OCPP-Backend und die Weboberfläche möglich ist, kann die Ladestation auch per Knopfdruck zurückgesetzt werden.
Achtung: Formatieren Sie den Speicher nur, wenn es notwendig ist. Beim Formatieren werden auch die Protokolle und das Frontend des Webinterface gelöscht. Um die Front-End-Dateien wiederherzustellen, lesen Sie bitte die Anweisungen zur Aktualisierung der Firmware. Wenn Sie technische Unterstützung benötigen, kontaktieren Sie bitte unser Support-Team über unsere Website www.EM2GO.de.
Seite 6
Table of contents Introduction ..........................7 Factory reset by OCPP backend ..................... 7 Factory reset by web interface ....................7 Factory reset by button ......................8 Format memory ........................8...
Introduction This guide describes the possibilities to factory reset the EM2GO EV charging stations of the Duo Power series. If needed, the EV charging station can be reset to factory (default) settings. Factory reset can be done in three ways: •...
Factory reset by button In case there is no OCPP backend and web interface accessible, it is possible to reset the EV charging station by button. To reset the EV charging station by button, proceed as follows: Open the covers of the two locks on the right side of the charging station and unlock the locks with the keys.
Seite 9
Caution: Only format the memory if necessary. Formatting will also remove the logs and the internal web interface front end. To recover the front-end files, please refer to the firmware update instructions. If you need technical support, please contact our support team via our website www.EM2GO.de.