Herunterladen Inhalt Inhalt Diese Seite drucken

nedis DTCTCO40WT Kurzanleitung Seite 12

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 14
Always notify the manufacturer if a problem with an
4
appliance is identified.
The product only measures CO in the area where it
4
is located.
Individuals with medical conditions that may make
4
them more sensitive to CO may consider using
warning devices which provide audible and visual
signals for CO concentrations under 30 ppm. For
additional information on Carbon Monoxide and
your medical condition contact your physician.
Hush mode
In hush mode, the product does not detect CO for 12
hours.
Power up and warm
up mode
Standby mode
Hush mode
Silenced alarm
Test
Low battery
condition
Information
Check Installation to
power the product. Warm
up lasts approximately
100 seconds.
After warm up, the
product will activate
standby automatically.
Press A
3
shortly to enter
hush mode.
Press A
shortly to
3
silence an unwanted
alarm.
Press and release A
3
to
test the product.
Replace the product
immediately.
The hush mode must be activated manually.
• Press the test/hush button A
hush mode. The alarm indicator blinks every 30
seconds
After 12 hours, the product goes back into standby
mode.
Only use the hush mode when the product is in line
4
of sight.
The product status is indicated through the display
A
4
and LED lights A
of the different statuses and indications is shown in the
table below.
LED indicator
A
, A
and A
1
2
7
blink alternately.
A
2
blinks green
every 30 seconds.
A
7
blinks yellow
every 30 seconds.
A
blinks red
1
continuous.
A
1
blinks red 4
times.
A
blinks yellow
7
every 30 seconds.
12
3
shortly to activate
1
, A
2
and A
7
. An overview
Sound alarm
Display
One short beep.
Off
None
Off
Off
Any number
between 25
- 999.
four beeps.
A beep every 30
seconds.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis