Installation Instruction - CFM 01 Benutzerhandbuch

5. Installation Instruction

When open the bike's carton box, take out E-bike and use tools to cut off the package
strings.
5.1. Install the handlebar:
5.1.1 Use inner hexagon tool to loosen the stem cover and don't tighten all bolts
immediately before adjusting the handlebar in a property angel and position.
5.1.2 Then tighten with tool.
5.2 Install front wheel:
5.2.1 Take out the front fork protector from the front fork.
(Please note: Front fork protector is used to prevent the forks from being deformed during
transport. It belongs to the packing material. You can just throw away this accessory!)
5.2.2 Take out the quick release from Wheel and unscrew the bolt from the quick
release.
-09-
5.2.3 Install the front wheel on the fork. Make sure the fork is attached to the axle
and make sure the disc is placed in the middle of the brake.
5.2.4 Insert quick-release axle into spring and tighten screw (Quick release nut to
be at the same end as the brake).
5.2.5 Inflating the tires
warning:
• The tire pressure should be checked each time before driving or at least once a week.
• Check the marked area on the sidewalls of the tire, which shows the minimum and
maximum tire pressure, and make sure that the tire pressure is in the marked area.If the
tire pressure is too low, the wheel may be damaged or the inner bicycle tube pinched,
which may result in a flat tire.If the tire pressure is too high, the tire may come loose
from the rim and thereby damage the bicycle or injure the driver and people in close
proximity.
• It is recommended to use a bicycle pump with built-in air pressure gauge to ensure that
your tire always has the desired and correct tire pressure.
5.3 Install the front light
5.3.1 Mount the headlight on the front fork bracket with screws.
-10-