AEG BSS 4812 Bedienungsanleitung, Garantie Seite 27

2. Chose the Bluetooth menu in your player and register
the device in your player. For this, refer to the opera-
tion manual of your player. The device "BSS 4812"
will show in your player as a selection.
NOTE:
Only one playback unit can be connected to the
speaker. If the speaker is already connected to
another playback unit, the speaker will not appear
in the BT selection menu.
3. Now enter the password "0000" in your player,
depending on the device manufacturers, model, and
software version.
A signal will sound after successful pairing.
For the further procedure, please refer to the user manual
of the playback unit. If possible, adjust the volume of the
external unit to a comfortable level.
NOTE:
• Depending on the device manufacturer, you need to
perform the registration (PAIRING) again to connect the
devices
• The Bluetooth compatibility cannot be ensured for
devices (e.g. mobile phones) getting released in the
future.
• To ensure an optimal connection, make sure that the
battery of your player is completely charged.
• Some of the mobile phone brands have an energy-sav-
ing mode. Deactivate the energy-saving mode as it can
otherwise result in problems during the data transfer
through Bluetooth.
• To be able to transfer audio data, Bluetooth needs to
stay activated in your player. Observe the operation
manual of your player.
• If a mobile phone on which you are playing music
receives a call, the music will be interrupted. The sound
however is not played back via the speaker. After you
have ended the call, the devices are connected to
each other again and playback continues. The volume
increases slowly.
• The AVRCP profile (Audio Video Remote Control
Profile) is not supported by this device!
USB connection
The USB port is only suitable for connecting a PC or a laptop.
When connecting such a device, please follow the on-screen
instructions.
NOTE:
• The USB port of the BSS 4812 does not support ex-
ternal hard drives or USB storage devices such as USB
sticks.
• Connect such devices to your PC first and then transfer
the data to your BSS 4812.
Cleaning
• Before cleaning disconnect from mains power supply.
• Clean the device with a soft damp cloth without deter-
gents.
• Do not submerge the device in water.
Troubleshooting
Fault Cause
Unit cannot be Unit crashes
operated. and "hangs".
No audio signal Speaker is not
via the Bluetooth paired to the
connection audio source.
Volume too
low
Speaker cannot Pairing does
be connected not work
Audio source
is switched off
Bluetooth is
switched off
at the audio
source.
Bluetooth
version is not
supported.
NOTE: Automatic standby
After a certain time without signal input, the appliance will
switch into standby mode automatically. This is in compli-
ance with the "ErP 2 (Energy-related Products)" Ecodesign
Directive (2009/125/EG), which aims at improving energy
efficiency and overall environmental compatibility of elec-
tronic devices. In order to use your appliance again, press
the VOLUME/INPUT control.
English
27
Solution
Disconnect from the
mains for around 5 sec-
onds. Then switch the unit
on again.
Check whether a connec-
tion exists. If necessary,
pair the speaker again to
the audio source.
Increase the volume on
the speaker
Increase the volume on
the audio source.
Check whether the audio
source supports the A2DP
protocol.
Switch on the audio
source
Switch on the Bluetooth
function in the audio
source.
Use a different playback
unit.