Installing The Refrigerator - hanseatic HEKS 12254A2 Gebrauchsanleitung

Page GB-18 Start-up

Installing the refrigerator

Before installation, check that the door
hinges are on the correct side. Change
the position of the door hinges if necessary
(see „Changing the door hinges" on page
GB-16).
For installation, you will need a PH2 cross-tip
screwdriver.
1. Switch off the fuse for the intended sock-
et (220-240 V~ / 50 Hz). Then insert the
mains plug into the socket.
2. Slowly and carefully push the refrigerator
into the built-in cabinet. Make sure that
the side to be opened is as close as pos-
sible to the wall of the cabinet.
(20)
(15)
3. There are holes pre-drilled in the out-
side edges of the appliance door for the
slides (15) to be attached. Use the short
screws (20) to fasten the slides on the
side that is to be opened.
4. Push the runners (17) into the slides (15).
Close and open the cabinet door to check
that it closes fully and easily. If necessary,
correct the position of the refrigerator.
All manuals and user guides at all-guides.com
5. Open the appliance door and cabinet
6. Remove the runners from the slides again.
7. Use 2 short screws (20) to fasten each
8. Press the covers (18) onto the runners.
9. Unscrew the slides again and push them
10. Screw the slides back onto the appliance
(17)
11. Press the covers (16) onto the slides.
door at the same time. As you do so,
mark the best position for the runners on
the inside of the cabinet door.
(17)
(20)
of the runners to the inside of the cabinet
door in the marked positions.
(17)
(18)
onto the fitted runners.
door.
(15)
(16)