Updating The Firmware - insta360 GO 2 Benutzerhandbuch

Notes
Accessories
GO 2 and its accessories contain small objects. Keep them out of children's reach to
•
prevent swallowing.
Avoid using all accessories in high-speed or high-intensity environments, otherwise
•
your camera or accessories may fall off.
As thick clothing can weaken the magnetic force of the Magnet Pedant, please do
•
not use GO 2 with thick clothing and always test GO 2's stability before shooting.
If you wear a cardiac pacemaker, do not wear the Magnet Pendant.
•
When using the Pivot Stand, please attach it to dry, clean and flat surfaces only.
•
Avoid attaching it to surfaces with strong vibrations.
Peel the Pivot Stand off surfaces from the edge of the base. Do not pull it off from
•
the center.
If the Pivot Stand has lost stickiness, clean with water and dry for re-use. After use,
•
place its original cover back on. Avoid sticking the Pivot Stand in high or low
temperature environments.

Updating the firmware:

Before use, please update the firmware of GO 2 and its charging case.
•
Before updating, ensure that both GO 2 and the charging case's remaining power is
•
not less than 50 %.
How to update via your computer (U-disk mode):
•
Step 1: Download the latest firmware from Insta360's official website.
Step 2: Use the included charging cable to connect the charging case (with GO 2
placed within) to your computer. Make sure both GO 2 and the charging case are
powered on.
Step 3: Copy the "InstaGo2FW.pkg" file you have downloaded to your GO 2 directly.
Delete the old "pkg" file first if there is one.
Step 4: Disconnect the charging case from your computer and GO 2 will power off
automatically. Close the charging case and open it again, then GO 2 will power on
automatically and start updating the firmware with a slow-flashing cyan light. After
finishing GO 2's firmware update, the charging case will start to update its firmware
as well. Please keep the charging case open.
For more information on updating the firmware, visit:
•
https://onlinemanual.insta360.com/go2/en-us/camera/firmware
To exit U-disk mode, please eject the device from your computer before unplugging
the charging cable.
8