Herunterladen Inhalt Inhalt Diese Seite drucken

Carmen ThermoCeramic Curl Power Gebrauchsanweisung Seite 9

Lockenzange
Inhaltsverzeichnis

Werbung

16 • English
• Do not use the appliance:
- when the mains lead is damaged
- when the appliance is visibly damaged
- when the appliance has fallen or been dropped
• Avoid dangerous situations. Never allow a person with motoric
deficits to use the appliance without supervision.
• Children do not understand the dangers of electric appliances.
Therefore, children should never be allowed to use electric
appliances without supervision.
• Keep the packaging materials (for instance the plastic wrapping)
out of reach of children.
• Extra safety can be achieved when an earth leakage circuit
breaker with a nominal trip current of no more than 30 mA
has been installed in the switch box. Consult an electrician
for advice on this matter. Dangerous situations can also arise
when the appliance is turned off. Therefore, the appliance's plug
should always be disconnected from the socket outlet after use.
• The mains lead of the appliance must not be replaced. An appli-
ance with a faulty or damaged mains lead can not be repaired
and must be disposed of as waste material. Have a service
provider authorised by the manufacturer inspect the product to
minimise risks.
• Use the appliance for its intended purpose only.
• Chemical waste: a defective appliance should be rendered unu-
sable. Consult your local authorities for information about waste
disposal regulations.
ThermoCeramic technology
The protective ceramic coating gives fast styling results and a
beautiful shine to your hair. ThermoCeramic technology offers:
• optimal transmission of heat through the hair
• fast and optimal styling results thanks to the ceramic coating
• in short: volume, stylish waves and curls within minutes!
› ›
Operating›instructions
Insert the plug into the socket outlet, and the on/off indicator will
light up. Within a few minutes the appliance will reach the correct
temperature. Always make sure the hair is dry before curling.
Curling tong
Before curling divide the hair into sections. Grasp a section of hair
at the ends with one hand, and hold the appliance in the other
hand. Open the clip of the curling tong by pressing on the tong
lever. Secure the hair ends between the clip and the tong, and
wind the hair in the desired direction. As you wind, make sure that
other hairs are not pulled along. The desired styling result depends
on the thickness of the hair section and the type and length of
hair. It is not advisable to wind very thick hair sections around the
curling tong. Winding thinner sections of hair around the curling
tong will result in smaller curls. Normally 8 to 10 seconds is long
enough to curl a hair section. Generally speaking thicker hair can
remain in contact with the curling tong for longer than thinner hair,
as less heat is needed to curl thinner hair.
To remove the hair from the curling tong, carefully unwind the hair
in a sideways direction. The tong lever allows you to release the
hair section from the curling tong. By repeating these steps you
can curl all hair sections.
Let the hair cool off for a couple of minutes before combing and/
or brushing.
Brush attachment
For styling and creating waves, curls and volume, slide the brush
attachment over the curling tong. Divide the hair into sections of
about 5 cm. Beginning at the ends, wind a hair section around the
brush and then continue winding towards the roots. It is important
to leave the brush in the hair for a few seconds to allow the heat
to be absorbed. Generally speaking thicker hair can remain on the
brush for longer than thinner hair, as less heat is needed to style
thinner hair. For best results, the hair sections should not be overly
17 • English
thick. Let the hair cool off for a couple of minutes before combing
and/or brushing.
› ›
Cleaning›and›maintenance
Disconnect the plug of the Multi Styler from the socket outlet.
Never submerge the Multi Styler in water. Do not allow dirt or
hair products to build up on the appliance. Always wait for the
appliance to cool down thoroughly before cleaning. Remove the
attachment and use a damp cloth to remove any build up on the
appliance and attachments. Then dry with a soft cloth.

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Ct4078

Inhaltsverzeichnis