Cable Connection - Elcon ELCONNECT fiber FOS 100w Kurzbedienungsanleitung

FOS 100w
Pin assignment of the RJ11 socket (
LED signalling
The modem has 5 LEDs which signal the power supply status and data transfer activities.
LED „PWR" (green): Power supply status
LED „WLAN" (green): WLAN status
LED „LINK" (green): Access network status
1", „ 2" (green): Status of the two analogue interfaces
LED „
2.5

Cable connection

1. Link the FOS 100w with the network interface card of the PC. For this, use an
Ethernet cable and connect it to one of the „LAN"-marked RJ45-sockets on the
FOS 100w and to the RJ45-socket of the network interface card (see the related in-
structions).
2. Your analogue telephones, fax equipment, answering machines, tariff metering appli-
ances, etc. shall be connected to one of the RJ11 sockets that are marked with the
symbol „ ".
Version: 2010/08/13
All manuals and user guides at all-guides.com
)
1 free
2 free
3 La (Line a to the a/b-interface of the subscriber line)
4 Lb (Line b to the a/b-interface of the subscriber line)
5 free
6 free
Figure 5: Pin assignment of the RJ11 socket
ON Supply voltage applied
OFF No supply voltage applied
ON WLAN activated
OFF WLAN deactivated
ON Connection to Access Switch established
FLASHES (discontinuously) in line with the bit clocking sequence
FLASHES (at 1 Hz) Booting procedure or no link to the Access
Switch (line interrupted, attenuation too high)
ON SIP-registration executed correctly, receiver hung
up (on-hook
FLASHES (at 4 Hz) SIP-registration is missing
FLASHES (at 1 Hz) Telephone or other terminal unit is ringing
OFF Receiver removed (off-hook)); no user configured
by provider
17