Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
FOS 100w
2 Installation
2.1
Hardware requirements / Minimum system requirements for installation of the
FOS 100w
• Power socket providing nominal voltage 230 V / 50 Hz
• ELCONnect fiber Pre-Installation Box (PI box) with connected optical fiber cable
from operational Access Switch
• Laptop or PC running on OS Windows
full-duplex network interface card (interface: 10/100Base-T); CPU: Pentium II
500 MHz or higher
2.2
Scope of delivery
• 1 FOS 100w with external plug-in power supply unit 12 V
• 1 short operating manual
2.3
Fixing the device
The FOS 100w has been designed for in-house use in closed rooms and shall be latched onto
the connected PI box that has been mounted on the wall before. First remove the dust-
protective cover from the fiber connectors both at the PI box and the FOS 100w.
In order to protect your eyes from irreparable damage, do never look directly or
indirectly (e.g. via mirror) into the laser beam, i.e. at the edge of the fiber cable or
the related connector.
Do never touch the open ends of the optical fiber connector, otherwise they could
be damaged.
Version: 2010/08/13
All manuals and user guides at all-guides.com
Fiber
Ethernet
WLAN
Router
802.11 b/g
or
Bridge
WLAN
Ethernet
Access Point
LAN
Figure 2: Block diagram
®
2 × POTS
VoIP
2 × POTS
98 SE, ME, 2000, XP; MAC; Linux and
, 1.2 A
®
,
15
Werbung
Inhaltsverzeichnis
