Inhaltsverzeichnis
Werbung
OBJ_BUCH-1676-002.book Page 11 Tuesday, October 22, 2013 11:57 AM
Please take care to place down the pole pruner with the oil filler
cap facing upward.
When storing in the sales packaging, the oil reservoir must be
completely emptied.
Do not modify this product. Unauthorized modifications
may impair the safety of your product and may result in in-
creased noise and vibration.
Technical Data
Pole Pruner Attachment
Article number
Chain bar length
Chain speed (no-load)
Chain, width
Oil tank volume
Weight according to
EPTA-Procedure 01/2003
without power unit
Serial number
Declaration of Conformity
We declare under our sole responsibility that the product de-
scribed under "Technical data" in combination with power unit
AMW 10 (3 600 HA3 0..) is in conformity with the following
standards or standardization documents: EN 60335,
En ISO 11680-1 according to the provisions of the directives
2011/65/EC, 2004/108/EC, 2006/42/EC, 2000/14/EC.
2000/14/EC: Guaranteed sound power level 107 dB(A).
Equipment category: 25
Technical file (2006/42/EC) at:
Bosch Lawn and Garden Ltd., PT-LG/ENS,
Stowmarket, Suffolk IP14 1EY, England
Henk Becker
Helmut Heinzelmann
Executive Vice President
Head of Product Certification
Engineering
PT/ETM9
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
22.10.2013
Troubleshooting
Problem
Possible Cause
Saw chain dry
No oil in reservoir
Oil passage clogged
Saw chain/guide bar hot
No oil in reservoir
Chain tension too high
Dull saw chain
Bosch Power Tools
Noise/Vibration Information
The following information is applicable for the attachment oper-
ated by the power unit:
Measured sound values determined according to
EN ISO 11680.
Typically the A-weighted noise levels of the product are: Sound
pressure level 84.5 dB(A); sound power level 104.5 dB(A). Un-
certainty K =2.5 dB.
Vibration total values (triax vector sum): Vibration emission val-
ue a
AMW SG
0 600 8A3 B..
Mounting and Operation
mm
300
m/s
12
Action
mm
1.3
Delivery Scope
ml
150
Open cover
Assemble / tension saw chain
Fitting the multi-tool attachmentt
kg
1.55
Filling oil
see type plate on the gar-
Working Advice
den product
Storage
Selecting Accessories
Unfasten the locking knob on cover.
Turn the chain locking screw in housing next to the chain bar
clockwise to tension and anti-clockwise to loosen the saw chain.
The saw chain is correctly tensioned, if on top it can lifted off
2 –3 mm.
Tension the locking knob. Pull the chain in reverse with your
hand. The saw chain must glide easily on the chain bar but not be
too loose off the bar.
2
= 4.5 m/s
, Uncertainty K= 2.5 dB.
h
Tension saw chain
Corrective Action
Refill oil
Clean oil passage
Refill oil
Tension saw chain
Sharpen saw chain or replace
F 016 L70 917 | (22.10.13)
English | 11
Figure
1
2
3
4
5
6
7
8
Werbung
Inhaltsverzeichnis
