Steam Ironing; Steam Shot - Water Spray; Dry Ironing; Cleaning - TREVIDEA G3FERRARI OPERA Bedienungsanleitung

•
Sometimes the clothing becomes shiny, in this case you need to iron it on the inside not to ruin it. When
ironing at maximum temperature (MAX), it is recommended to place a cloth between the ironing plate
and the fabric.
Setting the temperature
1) Place the iron vertically.
2) Plug the device to the electrical outlet.
3) Select the temperature regulator (10) according to the symbols shown on the previous page. The chosen
symbol has to be aligned with the mark placed on the tank. The iron plate temperature control light
shows that iron plate (8) is warming up. Wait until light turns off to start ironing.
Caution: While ironing, the control light lights up periodically indicating that the temperature is constant. If
you lower the thermostat, do not start ironing until the iron temperature control light turns off.

STEAM IRONING

Before using the steam check that the water contained in the tank is enough. Adjust steam power using the
control knob (3). Place the steam control knob between minimum and maximum depending on the amount of
steam required and temperature.
Caution: the iron provides continuous steam only if it is held in a horizontal position and if the plate is hot. It
is possible to stop the continuous jet of steam by placing the iron vertically or placing the steam control (3) to
"0". To avoid the dripping of water, it is recommended to only use steam at high temperatures.
STEAM JET – WATER SPRAY
Steam jet
: press the steam-shot button (4) for having a vigorous jet of steam which can penetrate the fibers
and soften even the most stubborn creases. Wait a few seconds before pressing.
By pressing the button periodically is also possible to freshen up curtains, hanging clothes, etc ...
Caution: the steam shot function can only be used at high temperatures; stop the jet when the temperature
control light lights up, start again when it goes out.
Water spray
: press the water spray button (5) slowly for having dense spray; press fast for vaporized spray.
Caution: make sure there is water in the tank. For delicate fibers it is advisable to moisten the article before
using the spray. To prevent stains, do not use the spray over silk and synthetic fibers.

DRY IRONING

To perform dry ironing, move the steam regulator (3) in "0" position. In this position, the steam emission is
disable, otherwise the water spray option is still unable.

CLEANING

Before cleaning any part of the product, ensure that the unit is unplugged from the electrical outlet and
the ironing plate isn't hot anymore.
Any leftovers on the ironing plate can be removed with a damp cloth or with a non-abrasive detergents. Do
not scrape the ironing plate with iron sponge or metal objects.
The plastic parts can be cleaned with a damp cloth and neutral detergent, then wiped with a dry cloth. Do not
immerse the unit in water.

BEFORE STORING

•
Unplug the system from the outlet.
•
Empty the water tank by turning the device upside down and shake it gently.
•
Allow the plate to cool down completely.
•
Wrap the power cord in the back of the body.
•
Leave the electric iron vertically.

TECHNICAL FEATURES

•
Power supply: AC 230V~50 Hz. 2000W power
•
Water tank capacity: 230 ml
13