Detergent And Dishwasher Use - Indesit DPP 48T9 Gebrauchsanleitung

Detergent and
dishwasher use
Measuring out the detergent
EN
Good washing results also depend on the correct amount of
detergent being used. Exceeding the stated amount does not
result in a more effective wash and increases environmental
pollution.
The amount can be adjusted to the soil level.
In the case of normally soiled items, use approximately either
35g (powder detergent) or 35ml (liquid detergent). If tablets
are used, one tablet will be enough.
If the crockery is only lightly soiled or if it has been rinsed
with water before being placed in the dishwasher, reduce the
amount of detergent used accordingly.
For good washing results also follow the instructions shown
on the detergent box.
For further questions please ask the detergent producers.
To open the detergent dispenser use the opening device "A".
Introduce the detergent into the dry dispenser "B" only.
Place the amount of detergent for pre-washing directly
inside the tub.
1. When measuring out the detergent refer to the Table of wash
cycles to add the proper quantity. Compartment B comprises a
level showing the maximum quantity of liquid or powder detergent
that can be added to each cycle.
2. Remove detergent residues from the edges of the dispenser
and close the cover until it clicks.
3. Close the lid of the detergent dispenser by pulling it up until
the closing device is secured in place.
The detergent dispenser automatically opens up at the right time
according to the wash cycle.
If all-in-one detergents are used, we recommend using the TABS
option, because it adjusts the cycle so that the best washing and
drying results are always achieved.
Only use detergent which has been specifically designed
for dishwashers.
DO NOT USE washing up liquid.
Using excessive detergent may result in foam residues
remaining in the machine after the cycle has ended.
To achieve the best washing and drying results, the combined
use of detergent, rinse aid liquid and refined salt is required.
We recommend using detergents that do not contain
phosphates or chlorine, as these products are harmful
to the environment.
12
Starting the dishwasher
1. Press the ON/OFF button.
2. Open the door and pour in a suitable amount of detergent.
(see detergent)
3. Load the racks (see Loading the racks) and shut the door.
Select the wash cycle by the P button.
4.
5. Select the wash options (see Special wash cycles and options.)
6. Start the cycle by pressing the Start/Pause button: a beep
sounds to signal the start of the wash cycle. The washing indicator
light goes on and the time remaining until the end of the cycle
is displayed.
7. At the end a few beeps signal the end of the washing cycle
and the END indicator light goes on. Switch off the appliance by
pressing the ON/OFF button.
8. Wait a few minutes before removing the crockery to avoid
getting burnt. Unload the racks, beginning with the lower level.
The machine will switch off automatically during long
periods of inactivity in order to minimise electricity
consumption.
:
AUTO WASH CYCLES
equipped with a special sensor which can be used to assess the
level of soiling and automatically select the most efficient and
economic wash cycle accordingly. The duration of the auto wash
cycles may vary due to the operation of the sensor.
Changing a wash cycle in progress
If a mistake was made in the wash cycle selection process, it is
possible to change the cycle provided that it has only just begun:
once the wash cycle has started, in order to change the wash
cycle switch off the machine by pressing and holding the ON/
OFF/Reset button. Switch it back on using the same button and
select the desired wash cycle and options.
Adding extra crockery
Press the Start/Pause button (the corresponding indicator light will
flash). Open the door, taking care to avoid the escaping steam,
and place the crockery inside the appliance. Press the Start/
Pause button (fixed light): the cycle will resume after the beep.
If the Start/Pause button is pressed so as to pause the
machine, both the wash cycle and the Delayed Start function (if
selected) are interrupted.
At this stage the wash cycle cannot be changed.
Accidental interruptions
If the door is opened during the wash cycle, or if there is a power
cut, the cycle stops. It starts again from the point at which it was
interrupted once the door has been shut or once the electricity
supply is restored.
*
Only available in selected models.
some models of dishwasher are