Legs/Feet; The Handle Installing; Metal Storage Shelves - CASO DESIGN Dry-Aged Cooler Original Bedienungsanleitung

 Locate the appliance away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may
increase electrical consumption.
 Ambient temperature below 10°C or above 32°C will hinder the performance of the
appliance.
 This unit is not designed for use in a garage or any other outside installation.
Do not set up the device in a hot, wet or extremely damp environment or near flammable

material.
 The device requires an adequate flow of air in order to operate correctly. Leave a
clearance of 15 cm around the appliance.
 WARNING! Do not close the ventilation openings in the device housing.
 The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
 The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies / electricians, provided they
guarantee the prerequisites for the safe use of this device.
 For energy saving reasons please ensure that the door is closed when the appliance is
turned on.
14.5.2

Legs/feet

There are feet (3 bigger feet and 1 small foot).
To level your appliance, adjust the front legs at the bottom of the appliance.
14.5.1

The handle installing

All manuals and user guides at all-guides.com
The wine cooler comes with one metal
stainless steel handle. To install simply
screw them to the door with the supplied
screws.
To do this, slide the rubber seal on the
back of the door to the side to lay open the
predrilled holes. Use the included screws
to install the handle on the door.
Then reinsert the rubber seal in the correct
position.

14.5.1 Metal storage shelves

Each metal storage shelf can be removed
to make it possible to store larger pieces of
meat.
35