Alignment Settings - Panasonic TX-21GV1C Serviceanleitung

ALIGNMENT SETTINGS:

(The figures below are nominal and used for representative purposes only.)
1) Place the TV in Programme position 70, set the Sharpness to minimum position, press the down button (- / v) on the
customer controls at the front of the TV and at the same time press the VCR INDEX button on the remote control, this
will place the TV into the Service Mode.
2) Press the RED / GREEN buttons to step up / down through the functions.
3) Press the YELLOW / BLUE buttons to alter the function values.
4) To exit the Service Mode, press the "EXIT" button.
Alignment Function
Blue correction
Green correction
Red correction
AGC
Sub AGC
Horizontal Centre
Vertical Size
Vertical Centre
Vertical Slope
S-Correction
OSD Language
OSD Position Set
All manuals and user guides at all-guides.com
B
23
G
23
R
24
AGC
41
SUB AGC 1
H-CENTER
32
V-SIZE
51
V-CENTER
30
V.SLOPE
32
S-CORR
20
OSD language
English
Français
Italiano
Español
Nederlands
Deutsch
OSD POSITION SET
10
Settings / Special features
Optimum setting (for white balance).
Optimum setting (for white balance).
Optimum setting (for white balance).
Set Pattern generator with RF level 60+/- 2dBuV,
210,25MHz. Connect oscilloscope to P101
(Tuner AGC input). Adjust AGC using
Yellow /Blue buttons until the voltage drops to
1.8V dc below its maximum voltage.
Press this button to access SUB TUNER AGC
adjustment.
Press once: picture is displayed in colour.
Press twice: picture is displayed in black and
white.
Optimum setting.
Optimum setting.
Optimum setting.
Optimum setting.
Optimum setting.
Adjust to change order of language selection
Optimum setting.