Indesit di 72 Installation Und Gebrauch Seite 22

Cleaning and Special Maintenance
Filter Assembly
For best performance and results, the filter assembly must
be cleaned .
The filter efficiently removes food particles from the wash
water, allowing it
to be recirculated
during the cycle.
For this reason, it
is a good idea to
remove the
larger food
particles trapped
in the filter after
each wash cycle
by rinsing the
"A" semi-circular filter and cup under running water. To
remove the filter assembly, pull on the cup handle in the
upward direction. The entire filter assembly (made up of
the "A" semicircular filter and the "B" fine filter) should be
cleaned at least once a month.
To clean the filter and the fine filter, use a cleaning brush.
Troubleshooting
It may occur that the dishwasher does not function or does
not function properly. Before calling for assistance, let us
see what can be done first: have you forgot to press one of
the buttons or to perform an essential operation?
The Dishwasher Does Not Start
Have you checked whether:
- the plug is pushed into the socket correctly;
- the power is on in the house;
- the door is closed properly;
- the ON-OFF switch is on "ON";
- the water supply is turned on.
The Dishwasher Does Not Load Water
Have you checked whether:
- the water is turned on and the hose is connected properly;
- the water supply to the house is on and has sufficient
pressure;
- the water supply hose is crimped or bent;
- the filter for the water supply hose is clogged.
The Dishes Are Not Clean
Have you put the right amount of detergent into the
dispenser?
Is the wash cycle suitable for the dishes you have placed
inside the appliance?
Are the filter and microfilter clean?
Can the sprayer arms turn freely?
The Dishwasher Does Not Drain
Have you checked whether:
- the drain hose is crimped or bent.
Lime Deposits or a White Film Form on the Dishes
Have you checked whether:
Then, reassemble the
filter parts as shown in
the figures below and
reinsert the entire
assembly in the
dishwasher, positioning in
its seat and pressing
downward.
The dishwasher must
never be used without
the filters. Improper
replacement of the filters
may reduce the performance level of the appliance and
damage dishes and utensils.
Cleaning the Sprayer Arms
It may happen that food particle become encrusted on the
sprayer arms and block the holes (see "Close up view
(interior)", letters F-I). Check the sprayer arms periodically
and clean them when needed.
- the lid to the salt container is closed properly;
- the rinse aid dosage is correct.
Error messages
The dishwasher is equipped with a safety system which is
able to detect any operating anomalies. These anomalies
are signalled by the rapid flashing of one of the indicator
lights "G".
Only when the rinses phase indicator light is flashing should
you cancel the wash cycle as described in the paragraph
entitled "Cancelling or modifying a wash cycle in progress",
then check whether there is any water in the mains supply
and that the water tap has been turned on. Start the wash
cycle again and if the message persists then call for technical
assistance, indicating which message appeared.
If the indicator light for a different phase form the rinses
one flashes rapidly, turn the appliance off, turn off the water
supply and call for technical assistance, stating which
indicator light was flashing.
If, despite all these checks, the dishwasher still does not
function and/or the problem persists, contact the nearest
authorised service centre and provide them with the
following information:
- the nature of the problem;
- the model type number (Mod. ...) and the serial number
(S/N ....), which are indicated on the plate located on the
side of the inner part of the door.
Never call on unauthorised technicians and refuse to
allow parts to be installed that are not original spare
parts.
19
A
B
GB