Blaupunkt FDD601 Bedienungsanleitung Seite 7

FDD601
1. Control panel:
a) power button
b) + and - buttons
c) setting mode button (time/temperature)
d) display
2. Ventilation and heating base
3. Trays
4. Cover
OPERATION
Prepare the products for drying. They should be of good quality, cleaned, without signs of
deterioration or mould. Cut them into smaller pieces so that their fragments are not thicker than 5 mm.
Wipe the trays with a damp cloth; make sure they are clean. Spread the products to be dried on the
trays so that they do not occupy more than ¾ of the surface area, leaving space between the elements
and ensuring free air flow.
Control:
- Press the power button to turn the appliance on or off
NOTE: after turning off the appliance, the fan will run for some time to cool its components down. Do
not disconnect the appliance from the power source until the fan is turned off.
- Press the setting mode button to change the drying temperature. The display will show the expected
temperature. The display will start flashing. It is possible to change the expected temperature with the
+ and – buttons while the display flashes.
- Press the setting mode button to set the timer. The display will show the time after which the
appliance will turn off (hours:minutes). The display will start flashing. While the display flashes, use the
+ and – buttons to change the setting of the timer.
NOTE: each press of the setting mode button alternates between the possibility to change the desired
temperature and the timer settings.
- When the set time has elapsed, the timer will turn the appliance off.
Recommendations:
- Since the temperature on the lowest trays is the highest, and those above them have a lower
temperature, it is recommended to change the position of the trays during drying.
- If the drying process takes a few days, check the condition of the dried products, and if any spoilage
or mould is observed – remove these products.
- To assess the condition of the dried products, remove a sample of the product and allow it to cool
down. Warm products seem to be moister.
CLEANING AND MAINTENANCE
Wipe the ventilation and heating base with a slightly damp cloth. Then wipe dry. Do not immerse in
water. Make sure that water and moisture do not get inside the appliance.
Clean the trays and the cover in water with washing-up liquid. Rinse thoroughly. It is not
recommended to clean these elements in a dishwasher (plastic may become dull).
5