FAMOS Roto Sealer F 220-Serie Bedienungshandbuch Seite 56

Communication with sealer
The communication between PC and sealer can only take place if following conditions are met :
- Correct machines (PC)
- Correct installation of software ( DOS / Windows)
- Correct connection between PC and sealer
- Correct selection of communication port
- Sealer in communication mode
If these conditions are met, you can exchange text between sealer and pc by means of sending or
receiving.
Sending text to sealer
This option offers the possibility of sending all texts that have been prepared on the PC to the sealer.
One has to take care that the communication port has been correctly set ( see furtheron in this chapter).
The sealer has to be put into the communication mode ( see earlier in this manual).
Further instructions follow on the screen.
Receiving texts from the sealer
This option offers the possibility of changing all texts that have been stored in the sealer, in the PC.
One has to take care that the communication port has been correctly set ( see furtheron in this chapter).
The sealer has to be put into the communication mode (see earlier in this manual).
Further instructions follow on the screen.
Emptying files
This option offers the possibility of deleting all pre-programmed texts in one handling.
Communication port
With this option one has to adjust the com-port through which the sealer is connected to the PC.
Mostly the connector to which the cable is connected is provided with the code COM1 of COM2.
End of the programme
Through this option the programme is ended. All information is automatically stored at the diskette or
the hard disk.
99.900.121 rev.:1
All manuals and user guides at all-guides.com
56