Hendi 3500 M Gebrauchsanweisung Seite 6

Preparations before using for the first time
• Remove all protective packaging and wrapping.
• Check to make sure the appliance is undamaged.
In case of incomplete delivery and damages.
Please contact supplier (See == > Warranty).
• Clean the appliance before use (See == > Clean-
ing and Maintenance).
• Make sure the appliance is completely dry.
• Place the appliance on a horizontal, stable and
heat resist surface that is safe against water
splashes.
Suitable cooking equipment
Bottom of cookware
Material
EN
Diameter of the bottom
Type of cookware
Note: Using a pan or pot that's not suitable for induction cooking may damage the appliance.
Operation
• Place a suitable cookware at the centre of the
heating surface of the appliance. (See --> Suita-
ble cookware for the appliance).
Note: Do not place empty cookware as this may
damage the cookware.
• Connect the power plug to a suitable electrical
supply outlet.
• Then, switch ON the appliance by turning the
knob (2) in clockwise direction.
• "ON" will be shown instantly on the display (1).
• Next, choose the power level by turning the knob
(2) clockwise.
• Minimal setting is 500W which increases in steps
of 100 W to the maximum setting of 3500 W for
item 239780 or 3000W for item 239315.
• Now, the appliance starts heating operation. The
set power will be shown on the display (1) during
cooking.
6
Suitable
Flat bottom
Cookware with iron, cast iron, magnetic stain-
less steel or enamelled iron bottom.
Between 12 cm and 26 cm.
Cookware with a bottom thickness over 1.5 mm.
• Ensure that there is sufficient ventilation. Keep a
minimum distance of 15cm around the appliance
bottom of cookware
• Do not place the appliance in close proximity to
devices which are sensitive to disturbances by
magnetic sources (e.g. radios, tape decks).
Note: Due to manufacturing residues, the appli-
ance may emit a slight odor in the first few cycles.
This is normal and does not indicate any defect or
hazard. Make sure the appliance is well ventilated.
Not suitable
Curved, uneven, rounded bottom
Cookware with ceramic, glass, copper,
bronze, or aluminium bottom.
Less than 12 cm or more than 26 cm.
Completely closed containers or cans.
• After cooking finished, you can turn off the ap-
pliance at any time by turning the knob (2) an-
ti-clockwise. "OFF" will be shown on the display
(1) for few seconds and then go off.
Note:
1). After an extended period of operation, it is nor-
mal for the cooling fan inside to continue run-
ning in OFF mode for some time. Before unplug
the appliance, wait until the cooling fan stops
running.
2). The appliance's surface is still hot even after
switch to OFF mode. Please wait the appliance
completely cool down before touching or clean-
ing.
3). If no cookware is placed on the heating surface
after switch ON, it will turn to OFF mode auto-
matically within 1 min.
4). If no any button on the control panel is pressed
during operation for 2 hours, the appliance will
then switch to OFF mode automatically.