Fail Safe Function - Amewi Raven 4x4 Brushless Bedienungsanleitung

Forward
The transmitter and receiver are already connected upon delivery. However, should it ever be necessary to rebind the transmitter
and receiver, proceed as follows:
1. Switch on the receiver (or controller) and press the SW button. The LED on the receiver starts to
flash.
2. Switch on the transmitter.
3. As soon as the LED on the receiver lights up continuously, the connection between transmitter
and receiver is established.
You can set a fail-safe function for this vehicle. This is activated if the connection between sender and receiver should break off.
Since the vehicle has a forward and a reverse gear, it is only possible to use the neutral position for the fail-safe function. In this
case, the vehicle rolls out.
Turn on the transmitter, turn on the receiver. Leave the throttle in the neutral position and press the SW button on the receiver for
about 2 seconds. The LED then flashes for 5 seconds. Release the SW button and switch off the receiver and transmitter.
OPERATING
Brake / Backward
Neutral
BIND TRANSMITTER & RECEIVER

FAIL SAFE FUNCTION

BEDIENUNGSANLEITUNG / INSTRUCTION MANUAL RAVEN 4x4
Neutral
Left
Right
33