Specifications; Regulatory Information; Safety Instructions - Interlogix TX-7211-05-1 Installationsanweisungen

Battery Threshold values
If the battery model BS7201-N is installed, verify receiver
settings below - and modify them if needed - so that the
threshold values for the battery voltage supervision (low
battery report) are set according to the table below.
Setting's path
RF receivers> RF Receivers 32> Sirens/ IO
Feat> RF Siren / IO x > Threshold > Low
Battery
RF receivers> RF Receivers 32> Sirens/ IO
Feat> RF Siren / IO x > Threshold > Low
AUX voltage
RF receivers> RF Receivers 32> Sirens/ IO
Feat> RF Siren / IO x > Anti-passivation
Siren configuration
To allow the IO module to control the output on the outdoor
siren, you need to cut jumper 3 and then optionally 1 and/or 2.
Jumper 3 is a start-up protection. Jumpers 1 and 2 are
responsible for timer settings, and you can cut one of them or
both, according to the table below. The maximum siren activity
time is limited both by hardware (jumper) setting, and software
(RF Receiver 32>Outputs>Siren/IO>Time) time setting,
whichever is shorter. For example, even if the software setting
for a siren is set at 255 minutes, and the jumper J1 is cut, the
siren will sound for 5 minutes only (i.e. according to the
hardware limit). When the same jumper is cut, and the time
value for the Siren/IO module is set to 1 minute, the siren will
stop after 1 minute.
Timer setting
Time J1
3 minutes (ex-factory)
5 minutes
10 minutes
20 minutes

Safety instructions

WARNING: Do not open the flash housing. Risk of high
voltage.
Battery replacement and removal
Caution: Batteries can explode or cause burns when
recharged, incorrectly (dis)assembled, or exposed to fire or
high temperatures.
Dispose of used battery according to battery directive
instructions and/or as required by local laws. Keep away from
children.
To remove the batteries from the outdoor siren, please pull the
black plastic strap that holds the battery pack. Only replace the
batteries with the standard lithium battery pack BS7201-N. Do
not use a different type of lithium batteries.
P/N 146636999-1 (ML) • REV B • ISS 18OCT13
Note:
the siren, and must be purchased separately.

Specifications

Power supply specifications
New value
Number and type of batteries
Change setting to
25x0.1V
Battery capacity
Change setting to
Electronics, board operating voltage
100x0.1V
Siren/flash light part operating voltage
Battery lifetime (typical)
Change setting to
Disabled
Current consumption – IO module
(typical)
Current consumption – siren (typical)
Current consumption – beacon
(typical)
Environmental
Operating temperature
Humidity
Shipping weight
EN 50131 grade and class
Certification
J2
*

Regulatory information

Manufacturer
Certification
The lithium battery pack BS7201-N is not included with
Assumption: maximum 20 siren activations of 3 minutes and
beacon activations of 15 minutes per year.
UTC Fire & Security Americas Corporation, Inc.
1275 Red Fox Rd., Arden Hills, MN 55112-6943, USA
Authorized EU manufacturing representative:
UTC Fire & Security B.V.
Kelvinstraat 7, 6003 DH Weert, Netherlands
2002/96/EC (WEEE directive): Products marked with
this symbol cannot be disposed of as unsorted
municipal waste in the European Union. For proper
recycling, return this product to your local supplier
upon the purchase of equivalent new equipment, or
dispose of it at designated collection points. For more
information see: www.recyclethis.info.
2006/66/EC (battery directive): This product contains
a battery that cannot be disposed of as unsorted
municipal waste in the European Union. See the
product documentation for specific battery
information. The battery is marked with this symbol,
which may include lettering to indicate cadmium (Cd),
lead (Pb), or mercury (Hg). For proper recycling,
return the battery to your supplier or to a designated
collection point. For more information see:
www.recyclethis.info.
BS7201-N, 4-cell custom
battery pack, lithium
(purchased separately)
12.5 Ah
3.0 VDC
12.0 VDC
3 years*
140 µA at 3.0 VDC ± 10%
340 mA at 12.0 VDC ± 10%
74 mA at 12.0 VDC ± 10%
−25°C to +50°C
max 95%, non condensing
2.3 kg
Security Grade 2,
Environmental Class III
EN 50131-1 System
requirements
EN 50131-4 Warning devices
EN 50131-5-3 Requirements
for interconnections
equipment using radio
frequency techniques
Tested and certified by
Telefication B.V.
3 / 21