Technical Maintenance And Deposit For A Long Time - Fuxtec FX-AD18 Original Bedienungsanleitung

8.Technical Maintenance and Deposit for a long time

1、daily maintenance
The following maintenance should be done after daily job
1) Cleaning the oil and dust on the surface machine
2) Clean chemical tank with clean water and dry it.
3) Check all the connections whether there is leakage of water or fuel. If there is
leakage, remedy procedures are very necessary.
4) Check all the screws to see if they are loose or lost. If there is , please screw tightly
or replace.
5) The battery must be charged before depositing. Charge before each using in case
short power.
6) The machine after maintenance should be put in dry and ventilating place. It must
be far away from fire source and avoid sunlight.
2、Deposit for a long time
The machine deposit for a long time should maintenance as follows:
1) Clean the machine surface carefully。
2) Discharge medicine in the tank and pump, clean them with clean water.
3) The battery must be charged before storing. If deposit for a long time, it should
be charged every two months.
4) All the plastic parts must neither exposed to the sunlight nor pressed by heavy
matter
5) Cover the machine with plastic dustcoat and store in a dry and clean place.
a) Cleaning
1)Clean chemical container
Callback remaining chemical liquid and wash it. Fill one liter water into chemical
tank and then swing it lightly.。
2）Clean the inside liquid pump
After cleaning chemical tank, fill clean water again and start liquid pump to mist to
clean the whole pipeline.
Original-Bedienungsanleitung Akku-Druckspritze FX-AD18_rev06
13