Initial Operation; Purpose And Mode Operation; Connection Of Peripheral Devices - Baaske Medical e-medic Silence XT-M Handbuch

Initial operation

When your e-medic™ computer has just been delivered do not under any circum-
stances connect it straight away! First unpack your new computer very carefully and
remove the protective foil. Then leave the computer standing in the room in which
it is to be used for at least 2 hours so that the computer can assimilate the room
temperature and any possible condensation moisture that has accrued can dissipate.
If moisture has built up on the housing wipe this off with a clean, antistatic cloth. As
long as there is moisture on the housing the computer must not be connected to the
mains supply.
Purpose and mode of operation
This unit is suitable for the storage and processing of data. This unit is developed for
long-term use in intermittent operation.

Connection of peripheral devices

Read the operating instructions of the devices to be connected very carefully and fol-
low the installation instructions of the respective products. The cable lengths of the
devices connected must not exceed 3 m, otherwise correct operation cannot be gua-
ranteed. Ensure the connectors are seated properly. If you have bought your Pro-Line
II computer with an additional graphic card the display connections on the mother
board are disconnected. Connect the monitor to be used to one of the graphics card
connectors. These are to found in the lower area at the back of the computer. With
connection to the motherboard sockets for the built in graphic device your monitor
will not function.
WARNING: With devices that provide the e-medic PCs with additional pow-
er via the connecting plug, the supply unit must also be checked according
to EN / IEC 60601-1.
24