Features; Package Contents; Wiring - LEGRAND C2G C2G30021 Bedienungsanleitung

HDMI HDBaseT + RS232 and IR over Cat Extender Single Gang Wall Plate Transmitter - 4K 60Hz

Features

HDMI 1.4 with 4K at 60Hz, 4:2:0, 8bit and HDCP 2.2 compliant
•
Extend 4Kx2K at 60Hz (4:2:0) up to 130ft and 1080p at 60Hz up to 230ft with Cat 6a/7 cable
•
Extend 4Kx2K at 60Hz (4:2:0) up to 115ft and 1080p at 60Hz up to 200ft with Cat 5e/6 cable
•
Supports one-way PoC, the transmitter can be powered by the receiver with PSE module.
•
Supports one-way IR pass-through from transmitter to receiver.
•
Supports CEC pass-through and RS232 pass-through via HDBT port.
•
Supports firmware upgrade through RS232 port, and can be set through the DIP switch.
•

Wiring

Note: Before installation, please ensure the unit is disconnected from the
power source.
1. Connect an HDMI source to HDMI IN port of transmitter.
2. Connect an HDMI display to HDMI OUT port of receiver.
3. Connect HDBT OUT port of the transmitter to HDBT IN port of an HDBT
receiver (such as C2G30015 or C2G30016) via a single Cat 5e/6/6a/7
cable.
4. Connect additional functions options.
IR pass-through: Connect IR receiver to IR IN port of the transmitter or
•
point display remote to IR window directly on front panel of the
transmitter, connect IR emitter to IR OUT port of the receiver, the
display can be controlled on transmitter side.
RS232 pass-through: Set the DIP switch to PASS-THROUGH position,
•
connect a RS232 enable device to RS232 port of the transmitter and
receiver respectively.
5. Connect the power adapter to the receiver.
Note: With one-way PoC function supported, the transmitter can be powered
by the receiver, no additional power adapter is needed to be connected to
the transmitter.
6. Power on all attached devices.
3

Package Contents

1 x Transmitter
•
1 x Phoenix Connector (3.5mm, 2 Pins)
•
2 x Phoenix Connector (3.5mm, 3 Pins)
•
1 x 1 – Gang US Socket Cover, White
•
(with Screws)
1 x Manual
•
(us)
(us)