Dmx Linking; Floor Mounting - Chauvet Professional Rogue Outcast 1 BeamWash Schnellstartanleitung

Power Linking
You can link up to 3 Rogue Outcast 1 Beam Wash products at 100 V, 4 products at 120 V, 7 products at 208 V, 7 products
at 230 V, or 8 products at 240 V. Never exceed this number. Power linking cords can be purchased separately.
To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely
disconnect the product from power via breaker or by unplugging it.
Replacing the Fuse
1. Disconnect the product from power.
2. Using a flat head screwdriver, unscrew the fuse holder cap from the housing.
3. Remove blown fuse and replace with a good fuse of the same type and rating.
4. Screw the fuse holder cap back in place and reconnect power.

DMX Linking

The Rogue Outcast 1 Beam Wash will work with a DMX controller using a 5-pin DMX serial connection. A DMX Primer is
available from www.chauvetprofessional.com.
DMX Connection
The Rogue Outcast 1 Beam Wash uses a 5-pin DMX data connection for its DMX personalities: 15Ch, 24Ch, 30Ch, 64Ch,
111Ch, and 135Ch. See the User Manual for information about connecting and configuring the product for DMX operation.
RDM (Remote Device Management)
Remote Device Management, or RDM, is a standard for allowing DMX-enabled devices to communicate bi-directionally
along existing DMX cabling. Check the DMX controller's User Manual or with the manufacturer as not all DMX controllers
have this capability. The Rogue Outcast 1 Beam Wash supports RDM protocol that allows feedback to make changes to
menu map options. Download the User Manual from
Mounting
Before mounting this product, read the
mounting clamps are capable of supporting the weight of the product. For our Chauvet line of mounting clamps, go to
http://trusst.com/productcategory/truss-clamps/.
Mounting Diagram
Omega bracket
Control Panel Description
Button Function
<MENU> Exits from the current menu or function
<ENTER> Enables the currently displayed menu or sets the currently selected value into the selected function
<UP> Navigates upwards through the menu list or increases the numeric value when in a function
<DOWN> Navigates downwards through the menu list or decreases the numeric value when in a function
Rogue Outcast 1 Beam Wash QRG Rev. 4
QUICK REFERENCE GUIDE
Safety Notes. Use at least two mounting points per product. Make sure the
Overhead mounting
www.chauvetprofessional.com
Mounting clamp
Safety cable
for more details.

Floor mounting

EN
2