Texi Zorro 110 Free Bedienungsanleitung Seite 28

TEXI Zorro 110 Free operation manual
Inspection and maintenance
Use only well sharpened blade. Any damage of the blade can affect work performance.
Greasing
Every 40 hours. Open the cup and give the small quantity of grease through the oil pot.
Sharpening
Always sharpen the knife when it's blunt.
Run the knife at the lowest speed (800 r.p.m.).
Gently push grinding wheel cup towards the blade and sharpen the knife for 2-3 seconds.
Inspecting the mounting screws
Regularly inspect all mounting screws and ensure that they are properly tightened.
If any of the screws be loose, retighten them immediately. Failure to do so could result in seri-
ous hazard.
A. Housing loosen handle: When cutting machine is in use, if appear housing loose, tighten 2
pieces MS sunk screw of aluminum base plate.
B. Lower blade loosen handle: When cutting machine is in use, if appear lower blade loose,
tighten the base plate fixed lower blade sunk screw, or adjust the lower blade with the includ-
ed angle of the round blade face, or adjust the lower spring and fastening screw according to
demand.
Workplace requirement
1. Workplace should be kept clean. Dust or other pollution can affect work of the knife.
2. The cutting machine should work under the normal temperature (10-45°C), relative
humidity should be less than 85%.
3. Before performing any technical adjustments (e.g. changing the blade, grinding stones
etc.), power must be switched off and lithium battery removed from the cutting machi-
ne, and the red power indicator is off.
4. When machine is not working, blade protective guard must be in its lower position.
5. After finish work switch off the knife and remove battery.
28