Texi Zorro 110 Free Bedienungsanleitung Seite 25

Basic operations
1. The power switch is located below the handle (1). Power switch activates blade - be
careful not to switch it on by mistake. Switch on the power only when your working
area including material for cutting is well prepared and you are ready to start the
work.
When power is on, red light (2) on the upper side of the handle will be on as well.
2. Speed adjusting.
Cutting machine TEXI Zorro 110 Free can work at 5 different speeds:
800/950/1100/1250/1400 r.p.m.
To choose required speed use multifunctional button (single press) which is located
on the top of the handle (2).
3. LED light.
To activate the LED light press continuously (for about 3 seconds) multifunctional
button (2). The same should be done to switch off the light.
TEXI Zorro 110 Free operation manual
25