Texi Zorro 110 Free Bedienungsanleitung Seite 23

TEXI Zorro 110 Free operation manual
GENERAL SAFETY PRECAUTIONS
To minimize the risk of fire, electric shock, or injury, observe the following precautions:
- Keep the workplace clean.
- Pay attention to the knife's work environment; do not subject it to atmospheric conditions.
- Do not operate in rooms that are dusty, where aerosols are sprayed, or to which oxygen is
supplied.
- Keep the workplace well lit.
- Be careful of danger of electric shock.
- Always switch off the knife before you start to replace the battery.
- Always switch off the knife and take out the battery before you start to replace blade or grind-
ing stone.
- Pay attention to clothing. Let-down hair or loose clothing can be caught by the knife's mobile
elements.
- Take care not to turn-on the knife accidentally.
- In case of even the slightest damage, always check if the damaged part requires replacement.
- Never install on the knife attachments and accessories other than those recommended by the
manufacturer and supplier.
- Do not perform knife modifications independently.
- Do not leave near the knife unattended bystanders or children.
- After finish work switch off the knife and remove battery.
- During the work protective guard must be on correct height. After finish work protective guard
must be on its lowest position (which covers blade on the whole surface).
- When the charger is not in use, disconnect it from the power grid.
Electric installation of the charger
Check if the supply voltage in the electric socket corresponds to the data on the charger 1-
phase voltage 230V 50Hz.
Check the correctness of electric connections in the plug and electric socket, observing elec-
tric shock safety countermeasures.
Do not use extension power cords, if you need to use one choose only high quality safe product.
Apply the valid electrical and Industrial Safety norms.
Use only original batteries dedicated to this knife.
Before starting work
Using knife without any of the safeguarding parts (guard) is forbidden as dangerous to an opera-
tor.
During work, only the items necessary for operating should be found on the work table.
Do not touch any of the machine's mobile elements during its operation.
Turn knife off before: replacing battery.
Turn off knife and remove battery before: replacing blade and other operation which
needs mechanical tampering.
If you notice any abnormalities in the knife's function, turn it off immediately and inform a me-
chanic or your superior. After finishing work, turn the knife off and remove battery.
This product is not a toy!
We hope that you will use this knife with pleasure for a long time.
23