Set Electricity Rate 1 And 2 - Silvercrest 56861 Bedienungsanleitung

All manuals and user guides at all-guides.com
Q 
note: the price per kWh is set to 0 on delivery.
note: you can set two different electricity rates (e.g. daytime
and night-time rate) for the power cost meter. In order to use
this function, you must set the starting times for electricity rate
1 and 2.
IMPOrTAnT! Electricity rate 1 is automatically the rate
that was programmed first.
from your electricity provider.
note: please make sure that the top third of the LC display
1 shows the standard display (see "Display current").
Proceed as follows:
1. Press the "DOWN" button 4 until the price per kWh
2. Press the "UP" button 5 so that four digits appear in the
3. Now press the "SET" button 2 . The first digit starts to
4. Press the "UP" 5 or "DOWN" button 4 to set the
56861_Energiekostenmessgeraet_Content_GB-HU-SI-DE.indd 23

Set electricity rate 1 and 2

Tip! You can obtain details of the current price per kWh
symbol 19 ("PRICE KWh") appears in the centre of the
LC display 1 .
bottom third of the LC display 1 . The
also appears.
flash.
units digit before the decimal point of the current price
Operation
symbol 15
GB 23
30.11.10 14:12