Shark Steam and Scrub Mopp Bedienungsanleitung Seite 20

CARING FOR YOUR STEAM AND SCRUB MOP
AFTER USE AND STORAGE
1
1 When the pads have cooled completely,
remove them by pulling them off the discs.
Dirt Grip PAD CARE INSTRUCTIONS
Machine-wash the Dirt Grip pads separately
with warm water using liquid detergent.
NEVER USE BLEACH, POWDERED
DETERGENT, OR FABRIC SOFTENERS
as they may damage the Dirt Grip pads
or leave a coating that will reduce their
cleaning performance and absorbency. Dirt
Grip pads should be line-dried or tumble-
dried on a low setting, as this will extend the
life of the microfibre fabric.
37
sh a rkclea n.eu
2
2 After the unit has cooled and the steam
has been released, empty the water tank
before storing.
Open the tank lid and pour the water out
into a sink or bath. After all the water has
drained out, close the lid.
3 To store the steam mop, wait until after
it has cooled and the steam has been
released. Store steam mop in a dry
protected area until next use.
Loose fibres can indicate wearing of the
microfibre fabric. DO NOT pull the loose
fibres as this can cause the weave to come
undone. Simply trim the loose fibres with
scissors.
Replacement Dirt Grip pads
For best cleaning results, we recommend
replacing the Dirt Grip pads every 3 to 4
months following normal use. As with any
fabric, dirt particles, grease, friction, and
repeated washing can cause the fibres to
break down, and you may notice an increase
in the effort needed to push or pull the mop.
ORDERING ADDITIONAL ACCESSORIES
ACCESSORY
Filling Flask
Makes it simple and convenient to fill the water tank.
Dirt Grip Pads
Easy-to-attach, reusable pads feature a super-absorbent
microfibre for locking in moisture and dirt, and scrubbing
material for breaking up tough, stuck-on stains.
You can purchase replacement Dirt Grip pads and other accessories by visiting sharkclean.eu.
38
s ha rkc l ea n.eu