Werbung
PROBLEM
Toilet does not flush or flush performance is poor
Water does not enter bowl during flush or water
add cycle
Water continues dripping briefly into bowl after
flush cycle is complete
Bowl drains dry after flush
NOTE:
This Troubleshooting Guide is intended to provide a basic service aid in the case of incorrect toilet operation. If the suggested actions above do not resolve
!
the issue, it may be necessary to bring unit in for professional service. Thetford Customer Service – 1-800-521-3032 .
www.thetford.com
Troubleshooting
CAUSE
Waste tank is full
Clog at pump inlet
Solid object in macerator
Low voltage
Water supply line kinked or not connected
No power to water pump
Water supply has been turned off
Solenoid not plugged into relay module (where
applicable)
Toilet is installed below water line with vented
loop in water supply line
Water is siphoning out of bowl due to discharge
hose pulled down
11
ACTION/SOLUTION
Empty waste tank before continuing to use toilet.
Clear clog. DO NOT flush foreign objects.
DISABLE power. Attempt to remove object. If unsuccessful,
contact Thetford/ Tecma Service (1-800-521-3032). DO
NOT flush foreign objects.
Check that toilet supply voltage is 12V+/-2V (24V+/-2V)
AND that there is no more than a 10% decrease in voltage
when macerator is running. If voltage decreases more than
this, there may be a wiring problem in the boat.
Check that supply line is properly connected to fresh water
supply. Check for kinks in the supply line.
Check that fuse/circuit breaker has not tripped. Ensure all
electrical connectors to water pump are fully mated.
Open water supply valves or reconnect power to supply
pump.
Ensure wiring harness to solenoid is fully connected.
Normal operation – if only a small amount of water drips
from nozzle.
Discharge hose
E
from macerator pump is
pulled down. Straighten
hose so that top of
Hose and nozzle
discharge hose is in line
must be level
with toilet nozzle.
Tecma EasyFit Owner's & Installation Manual
Werbung
Fehlerbehebung
