Wilfa CHA TM1-1500S Anleitung Seite 10

EN
11. After adding water, place the lid properly; lift up the tea bag (Fig. 6) after
covering the lid and then place the kettle on the base; insert the power plug
into the corresponding power socket and then the buzzer will beep twice and
all indicators is on for one second, so the kettle is at the standby state if no any
other operation.
12. The corresponding indicator will be on if the heating temperature is set, so the
heating will start when the on/off switch is pressed. The indicator will flash, the
buzzer will beep twice and the temperature indicator will be on if up to the set-
ting temperature, so the kettle is at the standby state if no any other operation
for one minute.
13. Press the keep warm button to start and press it again to cancel. Only the 70
°C, 80 °C, and 90 °C can be selected for insulation rather than 100 °C. If the
keep warm function has been selected, this function will be canceled if the
temperature is set to 100 °C. If the keep warm function is selected the on/off
switch must be pressed within one minute, otherwise the appliance will return
to standby mode. If the keep warm function is selected and the on/off switch
is pressed within one minute the keep warm function becomes active for 30
minutes.
14. When the appliance reaches the set temperature the indicator flashes, to
inform that water temperature has been up to or above this setting value;
15. If the keep warm function hasn't been selected and the kettle is removed from
the base the appliance will return into standby mode. If the keep warm function
has been selected and the kettle is removed from the base the appliance will
return to its current temperature state when the kettle is returned to base. If the
kettle isn't detected by the the base within one minute, the beep sound will be
given and the appliance will return to standby mode.
In standby mode, all LEDs are off and the heating process stops. In standby mode,
if there is no kettle on the base, all buttons and indicators disable.
Fig. 4
INSTRUCTION MANUAL · CHA
Lid-opening button
Fig. 5
10
Fig. 6