Futech MULTIPOWER 3.6 COMPACT Kurzanleitung Seite 18

to 10A AC, set the function
switch to the 10A position and
insert the red test lead banana
plug into the 10A jack.
∙ Press the MODE button to indi-
cate "AC" on the display.
∙ Remove power from the circuit
under test, then open up the
circuit at the point where you
wish to measure current.
∙ Touch the black test probe tip
to the neutral side of the cir-
cuit, the red test probe tip to
the "hot" side of the circuit.
∙ Apply power to the circuit
∙ Read the current in the display.