Checking And Changing Engine Oil Continued - Bohmer-AG AG-178-FD Handbuch

AG-178FD / AG-192FD

Checking and Changing Engine Oil Continued

To change the engine oil:
01. Place the machine on a suitable work surface that is flat and level and have a container ready to catch drained oil.
02. Clean the machine around the oil drain plug (B) and oil filler (A) so that no dirt or other material enters the engine when the plug or
cap is removed.
03. Unscrew (rotate left) and remove the drain plug and washer.
04. Tilt the machine and drain all oil from the engine. Once drained, allow the machine to sit level again.
05. Clean the drain plug and washer and then reinstall them. Screw in fully (rotate right) and firmly tighten.
06. Remove the oil filler cap (rotate left) until fully unscrewed. Wipe the oil level indicator clean with a piece of cloth or paper.
07. Using a funnel, carefully add oil to the engine until the "maximum" level is reached. Double- check the oil level (described above).
08. When finished, re-install (rotate right) the oil filler cap until firm. Wipe off any residual oil from the machine.
B
A
14 © Böhmer-AG 2020