Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Connect the connection cable (machine interface) to the safety sensor and
connect it to the machine control components as described in the original
operating instructions.
Pin assignment
Pin
Connection to MLD
1
24 V
2
MS2
3
0 V
4
MS1
5
RES/LMP
Step 5: Align and start up MLD530 muting transceiver
Switch on the safety sensor.
Adjust the height of the safety sensor and the Deflecting Mirror. After the
Allen screws are loosened
Adjust the axial alignment of the safety sensor and the Deflecting Mirror.
After the Allen screws
built-in device can be rotated slightly.
Step 6: Align and start up muting sensor sets
A: Position the sensors/reflectors.
Loosen the duct cover
Position the sensors/reflectors by moving in the axial direction
After aligning, retighten the Allen screw
Cut the duct cover to the appropriate length and remount
B: Align the sensors and reflectors.
Loosen the two Phillips screws
Turn to set the correct angle of the sensors/reflectors
After aligning, retighten the Phillips screws
The optimal alignment has been achieved when the green LEDs on the
muting sensors illuminate!
Checklist – prior to the initial start-up
Step 7: Edit
Start up the machine or system according to the original operating
instructions of the safety sensor.
Service hotline
You can find the contact information for the hotline in your country on our website
www.leuze.com under Contact & Support.
MS1
MS2
24 V
24 V
0 V
0 V
MS1
MS2
, the devices can be slid easily into the slot.
1
have been loosened, the entire column with the
2
and the Allen screw
1
.
4
LMP
24 V
RES/LMP
0 V
RES/LMP
.
2
.
2
.
5
.
4
EN
RES
24 V
RES/LMP
0 V
RES/LMP
.
3
.
1
11
Werbung
