Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
Work steps:
Step 1: Fasten the columns to the floor
Use the base plate to determine the mounting midpoint of the column and
make a mark on the floor.
Set the drilling template on the center point, align it and mark the bore holes.
Drill the fastening holes according to instructions and insert the floor
anchors.
Set the columns up and screw them on firmly.
Step 2: Align columns
Roughly align the column using the level
Align the column to the alignment screws
level.
Loosen the Allen screws
Spirit level
1
Alignment screws
2
Allen screws
3
Bore holes for floor anchors, Ø 10 mm
4
Plastic spring element with automatic resetting
5
Step 3: Fasten and align the Muting Sensor Sets
Select the position of the countersunk screw on the muting arm base
(1) Fixed setting:
Recommended setting with fixed 90 degree angle.
Position the countersunk screw so that it sits at the position for the fixed
setting and in the intended groove
(2) Variable setting:
In this setting, the pitch of the arms can be adjusted with the help of the
Allen screw
Position the countersunk screw so that it sits at the position for the
variable setting
Guide two sliding blocks into each of the slots
Screw the arms loosely into the sliding blocks at the intended height and
tighten the screws securely
Variable setting: Adjust the pitch of the sensors/reflectors with the help of
the Allen screw
Step 4: Establish the electrical connection
Connect the AC-SCM5-BT to the 5-pin socket of the safety sensor (local
interface).
Connect the MS1 and MS2 muting sensors to the respective socket of the
AC-SCM5-BT.
If necessary, connect additional components such as muting indicators and
start button to the AC-SCM5-BT.
10
and align the column axially.
3
.
5
and tighten it.
2
4
5
.
1
in a vertical position using the
2
and tighten it.
1
3
Werbung
