Environmental Conditions; Correct Disposal Of This Product - Delta Elektronika SM15K Serie Gerätehandbuch

SAFETY INSTRUCTIONS
1.11 Removal of (safety) covers
Safety cover(s) are used to cover potentially hazardous voltages.
Observe the following when removing safety cover(s):
Switch off the unit.
•
Disconnect the unit from the AC mains supply and from the DC power application.
•
• Wait for 5 minutes to allow internal capacitors to discharge.
• Unscrew the screws and remove the cover(s).
• Always place the cover(s) back before connecting the unit to the mains supply again.

1.12 Environmental Conditions

The Delta Elektronika power supplies safety approval applies to the following operating conditions:
• Indoor use
Ambient temperature
•
Maximum relative humidity
•
• Altitude
• Pollution degree
WEEE (Waste Electrical & Electronic Equipment)

1.13 Correct Disposal of this Product

Applicable in the European Union.
This marking shown on the product, its packing or its literature indicates that it should not be disposed with other
wastes at the end of its working life, but should be collected separately to recycle it responsibly to promote the
sustainable reuse of material resources.
3 / 31
: -20 to 50 °C
: 95%, non condensing, up to 40 °C
: 75%, non condensing, up to 50 °C
: up to 2000 m
: 2
DELTA ELEKTRONIKA B.V.
SM15K
Stand Juni 2019