Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Photoelectric Sensors
Diffuse reflective BOS 21M-..-RD10-..; BOS 21M-..-ID10-..
No. 828 400 E • Edition 0501
Diffuse reflection 1000mm
BOS 21M-PA-RD10-S4 (PNP)
BOS 21M-NA-RD10-S4 (NPN)
Diffuse reflection 2000mm
BOS 21M-PA-ID10-S4 (PNP)
BOS 21M-NA-ID-10-S4 (NPN)
Safety Advisory
The system is not permitted for use in applications
where personal safety depends on proper function
of the device.
The CE-Marking means that our products
conform to the requirements of the EC Guidelines
89/336/EWG (EMC) and the EMC Statute.
Testing in our EMC Laboratory, which is accredited by
DATech for Testing of Electromagnetic Compatibility, has
shown that these Balluff products satisfy the EMC
requirements of the following Generic Standards:
− EN 50 081-2 (Emission) and
− EN 50 082-2 (Noise Immunity)
Display and operating elements
Yellow LED
Output function indicator: The yellow LED ON indicates
that the output is active.
Green LED
Stability LED: The green LED ON indicates that the
sensor is ready and is working in a reliable range.
Potentiometer
The potentiometer can be used to adjust sensitivity.
Caution! Do not turn the potentiometer beyond the
mechanical stop at 270°.
1 yellow LED: Output function
indicator
2 green LED: Stability indicator
3 Potentiometer
Fig. 1: Display and operating elements
Connections
1 10...30 V DC
2 Output N.C.
3 0 V
4 Output N.O.
Fig. 2: M12 connector
3
Installation
There are three ways to attach the sensor:
1. Using two screws (M4) and washers through the
housing mounting holes.
2. Using a mounting bracket (available separately).
3. Using special clamps (available separately) and the
dovetail housing profile.
The operating distance is measured from the front surface
of the sensor optics.
The M12 connector can be oriented at four different
ratchet positions of 0°, 90°, 180° or 270°.
Fig. 3: Dimensions
Setting
1. Position the sensor at the desired distance.
2. Turn the potentiometer to minimum (shortest range) so
that the green LED is ON, the yellow LED is OFF.
3. Position the target In the beam path.
4. Turn the potentiometer slowly clockwise
until the yellow LED turns ON (Target
detected state, Pos. a).
5. Remove the target, the yellow LED turns
OFF.
6. Turn the potentiometer further clockwise until the yellow
LED turns ON (Background detected state, pos. b). If
no background is detected, Position b is covered with
the max. setting.
7. Turn the potentiometer to the intermediate position c.,
between the two positions a and b. The green LED
must be ON. Now the sensor is optimally calibrated.
a Receiver axis
b Emitter axis
c
a
b
min.
max.
SENS
Werbung
