Technical Data - VOLTCRAFT 2127443 Bedienungsanleitung

Power bank function
• The quick start system has a USB charging output. It can be used to portably charge small
electronic consumers.
• The USB output has overload protection.
• USB charging output "Output" (6): 5 V/DC max. 2.1 A
• To enable the power bank function, press the button for charge level indicator (1). The char-
ging output is released.
• Plug the devices to be charged (charging cable not included) into the USB charging output
(6). The included Micro USB cable for the quick start system is also suitable for devices with
a Micro USB connection.
• If you do not need the power bank function, remove the charging cable from the device.
The power bank output has overload protection and switches off automatically in
case of overload. If the output has been switched off by the system, remove the
charging cable from the device. Wait approx. 30 seconds. After that the output can
be re-enabled.
LED light function
The quick start system has a USB lamp.
To enable the light function, press and hold down the button for LED light (1) for approx. 3
seconds. The lamp is permanently lit. Another brief press switches the light mode.
Permanent light -> SOS signal -> Strobe light -> Off.
To disable the light function in any mode, press and hold down the button (1) for approx. 3
seconds. Disable the light function if you do not need it.
Do not look directly into the light source. The bright LED light source blinds the eye
and can cause short-term vision problems.
Disposal
Electronic products are raw material and do not belong in the household waste. At
the end of its service life, dispose of the product according to the relevant statutory
regulations.
Disposal of Flat Accumulators
You are required by law to return all used batteries. They must not be placed in household
waste.
Contaminated batteries/rechargeable batteries are labelled with symbols to indicate
that disposal in the domestic waste is forbidden. The abbreviations for heavy metals
in batteries are: Cd = cadmium, Hg = mercury, Pb =l ead (the marking can be seen
on the battery, e.g., underneath the refuse bin symbol shown on the left). Used
(rechargeable) batteries can be returned to collection points in your municipality, our
stores or wherever (rechargeable) batteries are sold.
That way you fulfil your statutory obligations and contribute to the protection of the environment!

Technical data

Vehicle on-board system ............................. 12 V/DC
Li-Ion battery capacity ................................. 7200 mAh, 14.8 V (26.64 Wh)
Starting current (peak value) ....................... 300 A (600 A)
Fit for engine sizes (capacity) ...................... petrol engine up to 4.0 litres
USB power bank (output) "Output" .............. 5 V/DC max. 2.1 A
Charging function (input) "Input" .................. Micro USB: 5 V/DC, 1.5 A
Li-Ion charging time 100% ........................... approx. 6 h
Charge level indicator .................................. 4 LEDs (25%, 50%, 75%, 100%)
Protection class ........................................... IP66 (dust and jet water proof)
Operating temperature ................................ -20 to +60 °C
Storage temperature .................................... 0 to 45 °C
Starter cable length ..................................... approx. 45 cm
Product dimensions (L x W x H) .................. 140 x 85 x 27 mm
Weight ......................................................... approx. 320 g
diesel engine up to 2.5 litres
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in
electronic data processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
This publication represent the technical status at the time of printing.
© Copyright 2021 by Conrad Electronic SE. 2127443_V2_0321_02_VTP_m_en