Connectors And Buttons - Axis Communications Q7414 Installationsanleitung

Green/Red
Red
Power LED
Green
Amber
Microphone power LED
Unlit
Blue

Connectors and Buttons

For specifications and operating conditions, see page 15.
Bus Connector
The bus connectors are the physical interfaces to the video encoder chassis that provide power,
network, RS485, and I/O terminal connections.
BNC Connector
Each video input is terminated using a coax/BNC connector.
Connect a 75 Ohm coaxial video cable; the recommended maximum length is 250 m (800 ft).
Note
75 Ohm video termination can be enabled/disabled for the video input through the
product's web page at Video & Audio > Camera Settings > Video termination. Video
termination is enabled on factory default. If the product is connected in parallel with other
equipment, for optimum video quality, it is recommended that video termination is enabled
only for the last device in the video signal chain.
AXIS Q7414 Video Encoder Blade
Flashes for identification purposes. To configure, go to Setup >
System Options > Maintenance. See the online help for more
information.
Flashes red for firmware upgrade failure.
Indication
Normal operation.
Flashes green/amber during firmware upgrade.
Indication
Phantom power off.
Steady when the phantom power is on and the microphone is
connected.
Flashes when the phantom power is on and the microphone is
disconnected.
11
EN