Philips SC1982 Bedienungsanleitung Seite 20

ENGLISH
20
7 The appliance immediately recharges for the next flash.
Depending on the intensity level selected, the READY/
skin colour warning light comes on after a few seconds.
This indicates that the appliance is ready for the next
flash. Choose one of the flash delivery methods and
continue to treat the areas you want to treat.
Note: If the treatment becomes painful at any point in time,
reduce the intensity level until the treatment is comfortable again.
If you notice skin reactions stronger than slight redness, stop the
treatment immediately and read chapter 'Possible side effects'.
Flash delivery methods
Slide & Flash
- Keep the flash button pressed. The appliance releases
one flash after another as long as the skin contact
surface is in full contact with the skin. After each flash,
slide the appliance to the next area. Continue to press
the skin contact surface onto the skin. This Slide & Flash
mode is especially convenient for treating larger areas
like the legs.
Step & Flash
- Let go of the flash button after each flash. For the next
flash, place the appliance on the area right next to the
area just treated. Make sure that the skin contact surface
is fully pressed onto the skin. This Step & Flash mode
guarantees a precise treatment of e.g. the knees or
ankles .
Note: Do not treat the same area twice during a treatment.
If you treat an area more than once, this increases the risk of
adverse effects.
Note: To avoid untreated areas, always make sure that there
is some overlap with the previously treated area when you
slide the appliance over the skin.The effective light only comes
out of the light exit window. Make sure that the flashes are
emitted close to each other.