Possible Faults - Scheppach PM1800D Originalbetriebsanleitung

Storage
Store the device and its accessories in a dark, dry and
frost-proof place that is inaccessible to children. The
optimum storage temperature is between 5 and 30˚C.
Store the electrical tool in its original packaging.
Cover the electrical tool in order to protect it from dust
and moisture.
Store the operating manual with the electrical tool.

Possible faults

Problem
Motor does not start.
Unusual vibrations
Device starts but blocks under
slight load and cuts off automa-
tically.
Heruntergeladen von manualslib.de
 www.scheppach.com  service@scheppach.com  +(49)-08223-4002-99  +(49)-08223-4002-58  www.scheppach.com  service@scheppach.com  +(49)-08223-4002-99  +(49)-08223-4002-58
Possible cause
No power supply (power failure)
Mains cable defective.
Motor or switch defect
Beater defective.
Chuck defective.
Non-intended material to be mixed.
Extension cable too long, or crosssection
too small.
Socket too far away from main connection,
and cross-section of connection lead too
small.
Handbücher-Suchmachiene
Remedy
Check fuses
Exchange defect cable, respectively check
extension cable, (by electrician)
Never use defect lead
To correct the problem, refer to the manuf-
acturer or other approved service centre.
Replace the beater.
To correct the problem, refer to the manuf-
acturer or other approved service centre.
Incorrect processing. Follow the processing
instructions from the supplier.
Extension cable at least 1,5 mm
25 m long.
Cross- section of at least 2,5 mm
cables.
, maximum
2
in longer
2
15 І 64