Electrolux LIC744I Montage- Und Gebrauchsanweisungen Seite 81

If no cooking zone is selected and the STAND-ALONE timer is not
active, the timer closest to the end of the countdown is displayed.
If no cooking zone is selected and the STAND-ALONE timer is
active, it is displayed with priority, with respect to the timer closest to
the end of the countdown.
The display mode of the countdown is the same for the
"STAND-ALONE" Timer (see previous paragraph "STAND-
ALONE" Timer)
When the timer has finished the countdown, an acoustic signal
sounds and the cooking zone switches off.
To switch off the Timer:
• select the cooking zone (2)
• set the duration of the Timer to
Note: If the induction hob turns off with the timer active, the timer will
continue to count down until the set time expires; if you wish to
manually stop the timer, it is necessary to turn the hob on again and
follow the timer switch-off instructions provided above.
Power Limitation
The Power Limitation function allows setting of the operation of the
product, limiting its maximum absorption.
Note: the setting must take place with the hob off, without pressing
the (1) key, when the hob is connected to the mains, or
when the electric mains are reconnected within the following 2
minutes.
To set the Power Limitation:
- press
(which will be flashing, only for the first 2 minutes after powering of the
product)
- continuing to hold down
Selection/Display (2) of the cooking zones, anti-clockwise starting
from the front right zone (FR)
- each press will be accompanied by a short audible signal
- once all the Displays (2) have been pressed, it will be possible to
release the key
at this point:
- the Display (2) of the left rear zone (RL) will show in alternate
sequence the symbols "C" and "0", indicating that it is possible to
perform the setting:
select the Display (2-RL)
then scroll on the Selection bar (3), until the symbols "C" and
"8",appear
, using (5)
press, one at a time, all the areas of
the Display (2-FL) will show the current setting**
0 = 7.4 KW
1 = 4.5 KW
2 = 3.1 KW
** by default the setting is 7.4 KW
To change the Power Limitation setting
- press the Display (2) of the left front area (FL)
- then scroll on the Selection bar (3), to select the new setting
- to save the choice made, press the
prolonged audible signal will be emitted to confirm the successful
setting
Bridge Zones
Thanks to the Bridge function, the cooking zones are able to work in
a combined manner, creating a single zone with the same power
level. This function allows evenly distributed cooking with large-sized
pots and pans.
The front "Master" cooking zone can be used in combination with the
corresponding "Secondary" cooking zone at the back
(to check which zones are equipped with this function, see the
illustrated part of this manual).
To activate the Bridge Function:
- simultaneously select the two cooking zones you want to use
- the Display (2) of the "Secondary" cooking zone shows the
symbol " "
- using the Selection bar (3), it will be possible to set the Level
(Power) of exercise, which will be shown in the Display (2) of the
"Master" cooking zone
- to deactivate the Bridge Function simply repeat the same
activation procedure
Note: the Cooking Timer Zone, activated during the Bridge
Function, causes the automatic shut-down of both cooking zones, as
in this case they are considered a single combined area.
USING THE EXTRACTOR FAN
Switch-on
Press (touch) briefly
continuing to press, all the available functions will become visible
for a few moments, e, after which only the main ones will remain
active; the others can be used, and will be activated,
subsequently, during use of the device.
IMPORTANT:
all the available functions will be illuminated with light intensity,
which will become more intense only when they are activated.
Press again to turn off
Note: This function has priority over the others.
• Starting the extractor:
Touch (press) the Selection zone (12) to activate the extractor
• Extraction speed (power):
The extractor is equipped with 3 levels of extraction speed (power)
Touch and slide your fingers along the Selection bar (3):
to the right to increase the level of power;
to the left to decrease the level of power.
The power level set will be displayed in the Selection/Display
area (12)
80
(1), for 2 seconds; a
(1) hob/extractor;