ZAMEL exta free SRP-02 Bedienungsanleitung Seite 8

RADIO TRANSMITTERS PROGRAMMING
LOCAL mode:
Press PROG push-button of SRP-02 device for a longer time until LED red diode
switches on (constant signal). Next release PROG push-button.
Press and release transmitter's first push-button (movement ). LED red diode
switches on (first signal pulsates, next the signal is constant).
Press and release the second transmitter's push-button (movement ). LED red
diode switches on (signal pulsates) and then switches off - THE TRANSMITTER
IS ADDED.
CENTRAL mode:
Press PROG push-button of SRP-02 device for a longer time until LED red diode
switches on (constant signal). Next release PROG push-button. Wait (for about
5 seconds) till LED red diode switches on (first signal pulsates, next the signal is
constant).
Press and release transmitter's first push-button (movement ). LED red diode
switches on (first signal pulsates, next the signal is constant).
Press and release the second transmitter's push-button (movement
red diode switches on (the signal pulsates) and next it switches off - THE
TRANSMITTER IS ADDED.
An exemplary programming procedure. The procedure for all radio EXTA FREE
transmitters is analogous with reservation that 2-channel transmitters can be pro-
grammed only in one mode - local or central.
CAUTION: If push-button changes are required for local and central control
(in a 4-channel transmitter) the programming procedure should be for two
modes separately (first local control push-buttons, then central control push-
buttons). In case of a 2- channel transmitter the change from local control to
central control should start with controller's memory deletion and only then
transmitter's programming procedure for central mode can start. One trans-
mitter can be added during one programming cycle. Full memory is signalled
with pulsating LED red diode.
COMFORT MODE TIME PROGRAMMING
Open the roller blind completely.
Press PROG push-button of SRP-02 device for a longer time until LED red diode
switches on (constant signal). Next release PROG push-button. Wait (for about
5 seconds) till LED red diode switches on (first signal pulsates, next the signal is
constant).
Wait again (for about 5 seconds) till LED red diode switches on (first signal
pulsates, next the signal is constant).
Press PROG push-button of SRP-02 device, next release PROG push-button -
the roller blind moves automatically.
If the roller blind is in a required comfort position - press PROG push-button and
release it - the roller blind stops - ROLLER BLIND MOVEMENT TIME IS ADDED.
). LED