Herunterladen Inhalt Inhalt Diese Seite drucken

HP LaserJet MFP M232-Serie Referenzhandbuch Seite 3

Vorschau ausblenden Andere Handbücher für LaserJet MFP M232-Serie:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 4
Help and tips for Wi-Fi and connectivity
If the software is unable to find your printer during setup, check the following conditions to resolve
the issue.
Potential Issue
Printer Wi-Fi setup mode timed out
Computer or mobile device too
far from printer
Computer connected to a Virtual
Private Network (VPN) or
remote work network
Wi-Fi turned off on computer
(computer connected by
Ethernet)
Bluetooth and location services
are turned off on your mobile
device
Help and Support
For printer troubleshooting and videos,
visit the HP support site. Enter your
model name to find the printer.
The information contained herein is subject to change without notice.
If the Wireless button
printer might not be in Wi-Fi setup mode. Restart
setup mode:
1. If the control panel is not lit, press
sleep mode.
2. Press and hold
the button. All control panel buttons will light up.
3. Press
and
at the same time once and then
release the buttons. The
4. Wait for one minute. Close and reopen
HP Smart, and then try connecting again.
Move your computer or mobile device closer to the
printer. Your device might be out of range of the
printer's Wi-Fi signal.
Disconnect from a VPN before installing HP Smart
software. You can't install apps from the Microsoft
Store when connected to a VPN. Connect to the
VPN again after finishing printer setup.
Note: Consider your location and the security of the
Wi-Fi network before disconnecting from a VPN.
If your computer is connected by Ethernet, turn on
the computer's Wi-Fi while setting up the printer.
Disconnect the Ethernet cable temporarily to
complete setup over Wi-Fi.
If setting up with a mobile device, turn on Bluetooth
and location services. This helps the software find
your network and printer.
Note: Your location is not being determined and no
location information is being sent to HP as
part of the setup process.
hp.com/support/ljM232MFP
Solution
is not blinking blue, the
to exit
for 5 seconds and then release
button will blink blue.
3

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Laserjet mfp m237-serie

Inhaltsverzeichnis