Philips GC6600 Serie Bedienungsanleitung Seite 8

ENGLISH
8
Safety auto-off mode (specific types only)
- To save energy, the steam generator switches off automatically when it has not been used for
10 minutes. The 'iron ready' light flashes.
- To reactivate the steam generator, set the on/off switch to 'off ' position and then to 'on' position.
Troubleshooting
This chapter summarises the most common problems you could encounter with the appliance. If
you are unable to solve the problem with the information below, visit www.philips.com/support
for a list of frequently asked questions or contact the Consumer Care Centre in your country.
Problem Possible cause
The iron does not There is not enough water in
produce any the water tank.
steam.
You have not pressed the
steam trigger.
You have set the temperature
dial to 1.
The Calc-Clean This is the Calc-Clean
light flashes and reminder.
the appliance
beeps.
The Calc-Clean You have not done or have
light flashes and/or not completed the Calc-Clean
the appliance process.
beeps.
The Calc-Clean You have not done or have
light flashes and not completed the Calc-Clean
the appliance process.
beeps every time
I press the steam
trigger. No steam
comes out of the
soleplate.
The appliance has The safety auto-off function
switched off. was activated. This happens
automatically when the steam
generator has not been used
for more than 10 minutes.
The appliance The water tank is empty.
produces a loud
pumping sound.
All manuals and user guides at all-guides.com
Solution
Fill the water tank beyond the MIN
indication. Press and hold the steam trigger
until steam comes out. It may take up to
30 seconds until steam comes out.
Press and hold the steam trigger until steam
comes out.
Turn the temperature dial to 2 or higher.
Perform the Calc-Clean process within
1 hour after the Calc-Clean reminder
is given.
Perform the Calc-Clean process to enable
the steam function again (see chapter
'IMPORTANT - Cleaning and maintenance').
Perform the Calc-Clean process to enable
the steam function again (see chapter
'IMPORTANT - Cleaning and maintenance').
Set the on/off switch to 'off ' position and
then to 'on' position.
Fill the water tank with water and press the
steam trigger until the pumping sound
becomes softer and steam comes out of
the soleplate.