Connecting To Your Computer - Cleyver Xflex Bedienungsanleitung

CONNECTING TO YOUR COMPUTER

1. Please, plug the Xflex to your computer using the provided USB-C
cable
2. Pull down from the status bar and then open then notification panel.
(see. picture 2)
3. « USB charging this device... » notification should show up. Click on
it to pick up one of the following USB connexion mode :
For standard files transfer (picture 3) :
4. Please, choose the « Transfer files » mode to access the Xflex's
internal memory and/or TF-card's content.
For transfering photos (picture 4) :
5. Please choose « Transfer photos (PTP) » mode : either your favorite
photo editor will launch automatically, or you will have exclusive access
to any folders which contain photos or pictures (ex : DCIM and Pictures
folders).
Note : the first time you connect Xflex to your computer, some drivers
might be installed. Please, wait for the drivers installation to finish
before accessing to the phone's memory content.
About connecting to a Mac computer, please use the following internet
address to download the appropriate software (Android Transfer) :
http://www.android.com/filetransfer/
Picture 3. Picture 4.
20