HEATSTRIP THAC-100 Bedienungsanleitung Seite 9

CAUTION:
To assemble this heater, you should obtain assistance from another person when handling the
larger, heavier pieces.
7
Install Top Post to the Lower Post
•
Insert and slide the top post over to the lower post connecting
the stand using 8 pan head screws (M6x10mm), then tighten all
screws securely.
Pan Head Screw M6x10mm
QTY: 8
8
Install the Heater to Bracket Head attached on the Upper Post
•
Using the 2 brackets, attach the brackets to the heater.
•
Match the brackets to the slotted holes located on the bracket head shown in the
diagram.
•
Using 2 Hex nuts bolts, tighten the heater brackets to the bracket head support
securely.
•
Ensure the heater is centred on the post.
Tip: Tilt the stand on a chair or a solid non-abrasive surface before
connecting the heater to the bracket head.
Hex Nut M12
QTY: 2
Assembly Instructions
9