HEATSTRIP THAC-100 Bedienungsanleitung Seite 8

CAUTION:
To assemble this heater, you should obtain assistance from another person when handling the
larger, heavier pieces.
4
Install Side Panels
•
Place two Side Panels onto the Base.
•
Install the Left Side Panel to the Lower Post using 2 Pan
Head Screws (M6x10mm). Then place the Left Side Panel to
the Base matching the slotted holes. Once the slotted holes
are matching, use 3 Pan Head Screws (M6x10mm) and
screw securely with the Flange Nuts.
•
Repeat the same procedure for the Right Side Panel, then
tighten all the screws securely.
Pan Head Screw M6x10mm
QTY: 10
Install Rear Panel
5
•
Place and install the Rear Panel to the Lower Post using
2 Pan Head screws. (M6x10mm)
•
Once the top 2 Pan Head screws are Installed, match the
slotted holes on the Rear Panel to the Side Panels.
Screws all 4 holes securely using 4 pan head screws
(M6x10mm) and Flange Nuts.
Pan Head Screw M6x10mm
QTY: 6
Install Heater Bracket to the Top Post
6
•
Place the bracket head on the top post.
•
Using the Bracket Head, match the slotted holes to the top post.
Once the slotted holes are matched, use 4 pan head screws
(M6x10mm), then tighten securely shown in the diagram.
•
Ensure bracket is attached in the correct direction, as per the
diagram.
Pan Head Screw M6x10mm
QTY: 4
8
Assembly Instructions
Flange Nut M6
QTY: 6
Flange Nut M6
QTY: 4