Troubleshooting; Disposal - MAXXMEE 5830169 Bedienungsanleitung

Designer Egg Cooker
Descaling
Limescale deposits in the heating bowl (5)
may have an adverse effect on the effi-
ciency of the device. It could also switch
off prematurely if the layer of limescale
is too thick. Limescale deposits should
therefore be removed with a standard
descaling agent depending on how often
the device is used.
For descaling follow the instructions on
the packaging or the package leaflet of
the descaling agent.
After descaling, wipe down the heating
bowl thoroughly and perform one boiling
process with the device using just water
and no eggs.

TROUBLESHOOTING

If the device does not work properly,
check whether you are able to rectify the
problem yourself. If the problem cannot
be solved with the steps below, contact
the customer service department.
Do not attempt to repair an elec-
trical device yourself!
The device cannot be switched on.
The mains plug is not inserted in the plug
socket correctly.
►
Correct the fit of the mains plug.
The plug socket is defective.
►
Try another plug socket.
There is no mains voltage.
►
Check the fuse of the mains connec-
tion.
The device switches off prematurely
after a short time.
The device has been switched on without
water or with too little water. The dry-run-
ning protection has been activated.
►
Allow the device to cool down for
approx. 5 – 10 minutes before water
is poured in and the device is used
again.
The device is furred up.
►
Descale the device.

DISPOSAL

Dispose of the packaging material
in an environmentally friendly man-
ner so that it can be recycled.
This device is governed by the
European Directive 2012/19/EU
on waste electrical and electronic
equipment (WEEE). Do not dispose
of this device as normal domestic
waste, but rather in an environmen-
tally friendly manner via an officially
approved waste disposal company.
EN
15